Using WiFi on Tab5 with the Arduino IDE

teastain

@smily77 said in Using WiFi on Tab5 with the Arduino IDE:

M5Stack Package 3.2.0

This board pkg (3.20) seems to be broken for many of us.
We have had to revert to ver2.14 and I have notified M5Stack support.

Try reverting and see.
If still a problem make a simpler de-bug version of your sketch and add complications.

smily77

@teastain thanks but unfortunatly doesn't the Tab5 exist in 2.1.4 an simpler than the below can't the sketch be made:

#include <M5Unified.h>
#include <WiFi.h>
void setup() {
auto cfg = M5.config();
M5.begin(cfg); // ← hier wird intern der C6 hochgefahren
WiFi.begin(ssid, password);
}

teastain

@smily77 a-HA!
Thank you.

felmue

Hi guys

the ESP32C6 is connected via SDIO bus to the ESP32P4 but unfortunately the GPIOs used in Tab5 differ from the GPIOs used by the ESP32P4 eval board.

In other words the pre-compiled Arduino library is setup to use SDIO GPIOs which do not match the Tab5 hardware.

So in order to use Arduino you'll need to pre-compile the Arduino library yourself using the Arduino library builder or setup the build system to use Arduino as ESP-IDF component. Both ways should allow to modify the SDIO GPIOs accordingly.

Note: the SDIO GPIOs used in Tab5 can be found here.

Thanks
Felix

smily77

@felmue

This applies as well if you use the M5Stack pkg? - is there a "how to" somewere for this?

felmue

Hello @smily77

no, AFAIK there is no specific 'how to' for M5Tab5 - only the generic about how to build your own Arduino library using Arduino library builder or how to use Arduino as ESP-IDF component. See links above.

Thanks
Felix

smily77

There seams to be an additional Issue the Tab5 uses SDIO2 - The correct GPIO's only don't work

felmue

Hello @smily77

I believe SDIO2 is used so the communication between ESP32P4 (master) and ESP32C6 (slave) can be exclusive, e.g. not shared with other slaves.

Thanks
Felix

New_Comix

Hi there,

are there any (better) news about using Wifi within the Arduino environment?

kind regards
Jörg

felmue

Hi guys

corresponding github issue for reference.

It seems there isn't an easier way just (yet) than using Espressif Library Builder.

Thanks
Felix