Ver 1.8.3 time: 2021.0827
- Add UNIT FADER support
- Add Module stepmotor driver support
- ESP-NOW support encrypt(LMK)
- New Vfunciton for UNIT V2
- Fix NB-IoT MQTT downlink data parse error
- Fix ATOM-DTU Modbus UART ID error
mory last edited by
good job! when will the desktop IDE be upgraded?
ajb2k3 last edited by
RGB leds won't work on M5Stamp if pins set to anything other that PORTA
dominiclee last edited by
I am beginner of M5Stack. I bought both M5Go and Fire, together with lots of units. When I test the OLED unit, I found it always show M5 logo with "M5STACK". i can 't fill with black or white. I can't draw rect. I can't draw line. I can't draw text. The only function works is "invert" but still only M5 logo with "M5STACK" is shown all the time. I tested it with both M5Go and Fire but same problem. Any help?
plusulli last edited by
with uiflow the OLED-unit shows nothing else than the M5Stack logo
add this block after any draw.
saitotetsuya last edited by
The range of ids of the Set id block in myCobot is wrong. It should be from 1 to 6, but from 2 to 7.